REVIEW

Effect of low-sodium silicate chemical grout on engineering properties of alluvial sand for soil liquefaction mitigation

This study investigates the effectiveness of low-sodium silicate chemical grout as a soil improvement agent for mitigating soil liquefaction in Lanyang Plain alluvial sand, Yilan, Taiwan. The chemical grout was prepared by mixing low-sodium silicate solution (JIS K 1408 No. 5, molar ratio 3.73) with a sulfuric acid-based coagulation catalyst at a water-to-silicate-to-catalyst weight ratio of 7:2:1. The gelation time was determined to be approximately 36 h at a viscosity threshold of 100 cP. Remolded specimens at relative densities of Dr = 20%, 30%, and 40% were prepared using the wet tamping method with chemical grout additions of 0, 5, and 10 wt% for mechanical tests and 0–6 wt% (with the dosage matrix adapted to relative density) for shaking table tests. Results showed that unconfined compressive strength (UCS) increased with both grout addition and relative density. Direct shear tests revealed a transition in the dominant shear strength parameter from friction angle to cohesion at grout additions exceeding 5 wt%, attributed to gelation-induced cementation. Permeability coefficients decreased with increasing grout content. One-dimensional consolidation tests indicated reduced compressibility and more stable volumetric strain in treated specimens. Scanning electron microscopy (SEM) confirmed progressive gel coating on sand particle surfaces, and Fourier transform infrared spectroscopy (FTIR) identified the formation of siloxane bonds (Si-O-Si), verifying the gelation mechanism. X-ray diffraction (XRD) identified crystalline sodium hydrogen sulfate, quartz originating primarily from the natural sand, and an amorphous silica-rich gel phase. Shaking table tests demonstrated that chemical grout addition effectively delayed the onset of liquefaction (excess pore water pressure ratio ru reaching 1.0) and reduced post-liquefaction settlement. Ultrasonic pulse velocity measurements further corroborated improved inter-particle cementation. These findings confirm the potential of low-sodium silicate grout as a soil improvement method for liquefaction-prone alluvial deposits; verification of its environmental performance is identified as future work.

1  Introduction

Soil liquefaction is a geotechnical phenomenon in which saturated, loose, cohesionless soils lose shear strength under seismic or cyclic loading due to the buildup of excess pore water pressure [1, 2]. Major liquefaction-induced disasters have highlighted the catastrophic

...
References

1. Sladen JA, D’Hollander RD, Krahn J. The liquefaction of sands, a collapse surface approach. Can Geotech J. 1985;22(4):564–78. doi:10.1139/t85-076.

2. Committee on Soil Dynamics of the Geotechnical Engineering Division. Definition of terms related to liquefaction. J Geotech Engrg Div. 1978;104(9):1197–200. doi:10.1061/ajgeb6.0000688.

3. Seed HB, Idriss IM, Arango I. Evaluation of liquefaction potential using field performance data. J Geotech Eng. 1983;109(3):458–82. doi:10.1061/(asce)0733-9410(1983)109:3(458).

4. Youd TL, Idriss IM. Liquefaction resistance of soils: summary report from the 1996 NCEER and 1998 NCEER/NSF workshops on evaluation of liquefaction resistance of soils. J Geotech Geoenviron Eng. 2001;127(4):297–313. doi:10.1061/(asce)1090-0241(2001)127:4(297).

5. Chao SJ, Hsu HM, Hwang H. Soil liquefaction potential in Ilan City and Lotung Town. Taiwan J GeoEng. 2010;5(1):21–7. doi:10.6310/jog.2010.5(1).3.

6. Yang X, Zheng K, Xu L, Liu N. Properties and applications of a new chemical grouting material. Adv Civ Eng. 2020;2020(1):7191354. doi:10.1155/2020/7191354.

7. Shahir H, Pak A, Ayoubi P. A performance-based approach for design of ground densification to mitigate liquefaction. Soil Dyn Earthq Eng. 2016;90(2):381–94. doi:10.1016/j.soildyn.2016.09.014.

8. Mollamahmutoğlu M, Avcı E, Deveci E, Gokce A, Yıldırım E. Strength and permeability properties of sodium silicate-sodium dihydrogen phosphate grouted sand. Arab J Geosci. 2021;14(19):2061. doi:10.1007/s12517-021-08427-y.

9. Inazumi S, Shang HM, Soralump S, Nakagishi Y, Miyatani Y, Mori Y, et al. Effect of the molar ratio of liquid glass grouting agents on mechanical characteristics of the solidified soils. Int J Geomate. 2014;7:985–92. doi:10.21660/2014.13.140314.

10. Ciardi G, Madiai C. Effects of initial static shear stress on cyclic behaviour of sand stabilised with colloidal silica. Acta Geotech. 2023;18(5):2389–409. doi:10.1007/s11440-022-01737-9.

11. Katoueizadeh E, Rasouli M, Zebarjad SM. A comprehensive study on the gelation process of silica gels from sodium silicate. J Mater Res Technol. 2020;9(5):10157–65. doi:10.1016/j.jmrt.2020.07.020.

12. Wang X, Wang C, Li P, Tian D, Wang J, Liu B. Experimental study on new grouting material of acidic sodium silicate and its properties of grouted-sand. Constr Build Mater. 2023;392(8):131955. doi:10.1016/j.conbuildmat.2023.131955.

13. Xu Y, Wei T, Chen G, Ma J, Yan M. Experimental study on the development mode and evolution mechanism of sodium silicate solidified sand under different temperatures and curing paths. Constr Build Mater. 2023;409(5):134073. doi:10.1016/j.conbuildmat.2023.134073.

14. Valibeknejad M, Sweijen T, Zech A, Quodbach J, Shahidzadeh N, Wolthers M, et al. Sodium silicate grouting: mechanisms, environmental impacts, and research directions. Transp Porous Media. 2026;153(6):78. doi:10.1007/s11242-026-02323-3.

15. Gallagher PM, Pamuk A, Abdoun T. Stabilization of liquefiable soils using colloidal silica grout. J Mater Civ Eng. 2007;19(1):33–40. doi:10.1061/(asce)0899-1561(2007)19:1(33).

16. Conlee CT, Gallagher PM, Boulanger RW, Kamai R. Centrifuge modeling for liquefaction mitigation using colloidal silica stabilizer. J Geotech Geoenviron Eng. 2012;138(11):1334–45. doi:10.1061/(asce)gt.1943-5606.0000703.

17. Spencer L, Rix GJ, Gallagher P. Colloidal silica gel and sand mixture dynamic properties. In: Zeng D, Manzari MT, Hiltunen DR, editors. Geotechnical earthquake engineering and soil dynamics IV. Reston, VA, USA: ASCE; 2012. p. 1–10. doi:10.1061/40975(318)101.

18. Cui Y, Tan Z, Han D, Song J. Investigation and application of a high performance grouting material in water-rich silty fine sand stratum. Constr Build Mater. 2022;329(2):127100. doi:10.1016/j.conbuildmat.2022.127100.

19. Rosa D, Al-Jamaei A, Di Palma L. Enzyme-induced carbonate precipitation process for soil improvement using expired soybean seeds as urease source. J Environ Chem Eng. 2026;14(3):122237. doi:10.1016/j.jece.2026.122237.

20. Cui MJ, Chu J, Lai HJ. Optimization of one-phase-low-pH enzyme-induced carbonate precipitation method for soil improvement. Acta Geotech. 2024;19(3):1611–25. doi:10.1007/s11440-023-02175-x.

21. Ahenkorah I, Rahman MM, Karim MR, Beecham S. Cyclic liquefaction resistance of MICP- and EICP-treated sand in simple shear conditions: a benchmarking with the critical state of untreated sand. Acta Geotech. 2024;19(9):5891–913. doi:10.1007/s11440-023-02222-7.

22. Seed HB, Peacock WH. Test procedures for measuring soil liquefaction characteristics. J Soil Mech Found Div. 1971;97(8):1099–119. doi:10.1061/jsfeaq.0001649.

23. Xu Y, Zhang Y, Huang J, Chen G. Mechanical properties, microstructure and consolidation of sand modified with sodium silicate. Eng Geol. 2022;310:106875. doi:10.1016/j.enggeo.2022.106875.

24. Avci E, Mollamahmutoğlu M, Deveci E. Sodium silicate-formamide grouted silt and silty sand properties. J Adhes Sci Technol. 2022;36(21):2269–84. doi:10.1080/01694243.2021.2010879.

25. Yoon JC, Son SW, Kim JM. Method for prevention of liquefaction caused by earthquakes using grouting applicable to existing structures. Appl Sci. 2023;13(3):1871. doi:10.3390/app13031871.

26. Ghorbani A, Hasanzadehshooiili H, Somti Foumani MA, Medzvieckas J, Kliukas R. Liquefaction potential of saturated sand reinforced by cement-grouted micropiles: an evolutionary approach based on shaking table tests. Materials. 2023;16(6):2194. doi:10.3390/ma16062194.

27. Kyaw KNC, Motohashi T, Sasahara S, Inazumi S. Evaluation of liquefaction resistance in chemically grouted sand using cyclic triaxial tests. Results Eng. 2025;27(1):106875. doi:10.1016/j.rineng.2025.106875.

28. Lee KL, Albaisa A. Earthquake induced settlements in saturated sands. J Geotech Eng Div. 1974;100(4):387–406. doi:10.1061/ajgeb6.0000034.

29. Ishihara K, Yoshimine M. Evaluation of settlements in sand deposits following liquefaction during earthquakes. Soils Found. 1992;32(1):173–88. doi:10.3208/sandf1972.32.173.

30. Duku PM, Stewart JP, Whang DH, Yee E. Volumetric strains of clean sands subject to cyclic loads. J Geotech Geoenviron Eng. 2008;134(8):1073–85. doi:10.1061/(asce)1090-0241(2008)134:8(1073).

Cite This Article

APA Style
Cheng, A., WuYin, J. X., Lin, W. T., Cheng, P. C., Huang, Q. Z. (2026). Effect of low-sodium silicate chemical grout on engineering properties of alluvial sand for soil liquefaction mitigation. ZKG International, 79(7), 92–106. https://doi.org/10.32604/zkg.2026.085050
Vancouver Style
Cheng A, WuYin JX, Lin WT, Cheng PC, Huang QZ. Effect of low-sodium silicate chemical grout on engineering properties of alluvial sand for soil liquefaction mitigation. ZKG Int.. 2026;79(7):92–106. https://doi.org/10.32604/zkg.2026.085050
IEEE Style
A. Cheng, J. X. WuYin, W. T. Lin, P. C. Cheng, and Q. Z. Huang, “Effect of low-sodium silicate chemical grout on engineering properties of alluvial sand for soil liquefaction mitigation,” ZKG Int., vol. 79, no. 7, pp. 92–106, 2026. https://doi.org/10.32604/zkg.2026.085050

Related articles:

×